Tag Archives: pir

20170628_211524s

Itead Studio Sonoff SC Revisited

A few months ago I wrote about the Sonoff SC sensor hub by Itead Studio. It’s a device with a Sharp GP2Y1010AU0F [Aliexpress] dust sensor, a DHT11 humidity and temperature sensor, an LDR as light sensor and a mic. The sensors are driven by an ATMega328P microcontroller but there is also an ESP8266 on board for WiFi communication, a pretty standard set up when you have several sensors and the ESP8266 GPIOs are just not enough.

20170105_125851s

On the first post I already did a small mod to replace the DHT11 humidity and temperature sensor with a more accurate and pin compatible DHT22. Since then, several readers have contributed with code and ideas. My progress implementing and testing them is slow, so I though about writing a first post about some modifications I (and others) have done to the device.

So this is a work in progress post. At the moment, all the code for these modifications is in the dev branch of the repository.

This custom Sonoff SC firmware is released as free open software and can be checked out at my SonoffSC repository on Github.

Continue reading

20161005_005107s

Sonoff TH10 & TH16: sensors, displays, actuators,…

Itead Studio keep on creating interesting products for the hacker community. A few weeks ago a new version of the already classic Sonoff TH came to life. This new version comes in two flavours: the Sonoff TH10 and TH16 and you can buy them at Aliexpress: Sonoff TH 10A/16A Temperature And Humidity Monitoring WiFi Smart Switch.

In this article I will briefly talk about what’s new in this device to quickly go to explore one of those novelties: it’s external interface.

Continue reading

S20 Smart Switch

S20 Smart Socket

Since I discovered the Sonoff I’ve been thinking about embedding it inside a switch. I started looking for old power meters, timers,… I had at home but the Sonoff is a bit too long. Why didn’t they design a square board? I event bought a bulky Kemo STG15 case with socket.

Next I decided to design my own board. It is meant to be the “official” hardware for the ESPurna project so it’s called ESPurna too. It’s opensource hardware and available at the ESPurna project repository at Bitbucket. I have some boards already for the first iteration (version 0.1). They are mostly OK but I’m already working on a revision.

But then ITead’s released their S20 Smart Socket. It’s the Sonoff in a wall socket enclosure. Almost 100% what I wanted. And at 11.70€ it’s hard to beat. There are other wifi smart sockets available, mainly Orvibo and BroadLink (an SP2 Centros should be arriving home anyday now) but ITead’s is cheaper and you can easily re-flash it. Just solder a 4 pins header, connect it to your FTDI programmer, hold the S20 button, connect the programmer to your computer and flash. Done.

OK, not so fast. Why would I do that? Why would I change the stock firmware?

The answer for me is a mixed up of philosophy and practicity. But you are right. Let’s go step by step.

Continue reading