One might think that one of the typical uses for a smart wireless switch (like Sonoff devices) is to be embedded behind a normal wall switch so it becomes a “smart” wall switch. It may seem obvious but it’s not that straight forward. There are several things that get in the middle.
- Most (all?) the boards have momentary push buttons while wall switches are (normally) toggle switches
- Most of the available boards in the market are SPST, even those with SPDT relays often only provide terminals for COM and NO, not NC. I only have one one-throw switch at home, all the others are one-way-two-throw and are being used as part of a multi-way switch.
First problem can be easily solved in code. Instead of detecting one edge of the button signal (usually the rising edge since most push buttons are configured with pull-ups) you can detect both edges.
Second problem is harder since it depends on the hard-ware (ehem). But there are a few boards out there with SPDT relays like the Itead 1CH board I recently covered, the e_Goto Wifi Relay Switch Module [Aliexpress] or the Your Cee ESP8266 5V WiFi Relay Module [Aliexpress]. There are also two-relay boards you can use for a multiway switch by syncing the relays in opposition mode using ESPurna firmware for instance (one and only one relay on). The Electrodragon ESP Relay board is one such boards. Another one is the Sonoff Dual.