Some weeks ago a tweet by Manolis Nikiforakis (@niki511) with the #ESP8266 hashtag drew my attention. Manolis had just received a “smart lamp” branded by Ai-Thinker, the AiLight. Yes, the same Ai-Thinker that has sold millions of ESP8266 based modules. Chances were it had an ESP8266 microcontroller inside. Too good not to buy one and take a look at the inside.
I actually bought two because you never know. And they arrived last Thursday. It took me less that 1 minute to open one of the boxes, pop out the cap and take a look at the inside just to see what I already knew. Time to play 🙂
One might think that one of the typical uses for a smart wireless switch (like Sonoff devices) is to be embedded behind a normal wall switch so it becomes a “smart” wall switch. It may seem obvious but it’s not that straight forward. There are several things that get in the middle.
Most (all?) the boards have momentary push buttons while wall switches are (normally) toggle switches
Most of the available boards in the market are SPST, even those with SPDT relays often only provide terminals for COM and NO, not NC. I only have one one-throw switch at home, all the others are one-way-two-throw and are being used as part of a multi-way switch.
First problem can be easily solved in code. Instead of detecting one edge of the button signal (usually the rising edge since most push buttons are configured with pull-ups) you can detect both edges.
Sometimes Chinese manufacturers throw a mysterious, unlabelled, IC into their designs so we can spend a few hours trying to figure out what they are and what they do. It’s such fun! I’ve been playing with one of those this afternoon, trying to answer those questions but also trying to understand why! Why is that chip there? Why did someone decided she needed that chip there?
Some weeks ago a user of ESPurna asked me if the firmware supported Itead’s 1CH self-lock/inching board. My answer was “why not” since all Itead’s products are very much alike. Wrong. This one is different. Let me summarise why:
There is no entry in the Itead’s wiki for the device
There are no schematics, drawings, in the store
It uses (and brings out) a Songle SRD-05VDC-SL-C SPDT relay (there is only one other product using this relay in Itead Studio store)